Tel: +86-15997961520   Email:  664950338@qq.com
OEM-banner
You are here: Home » OEM&ODM

Customization Process​​​​​​​

  • Substrate treatment
    • 1. Rust removal, oil removal, and old paint film removal
      2. Thoroughly clean
      3. Spray phosphating primer
      4. Clean and let stand for half an hour
  • Epoxy primer
    • 1 layer 10-18 microns
      Applicable surface:
      1. Existing coatings on aluminum, steel, stainless steel, galvanized steel or zinc surfaces
      2. Polyester laminate, wood or plywood, atomic gray.
  • Scraping atomic ash
    • 1. Scrape atomic ash onto the surface of the car body to fill in surface defects
      2. Scratch and apply multiple times on areas with deeper depressions to avoid sand holes and bubbles caused by excessive film thickness.
      3. After the atomic ash solidifies, dry grind with P80 or P120 sandpaper.
      4. According to the grade quality of the car body surface, atomic ash can be repeatedly scraped and coated multiple times to ensure a smooth and defect free surface.
  • Two component intermediate paint
    • 2-layer spray coating of 40-60 microns
      Guidance layer paint mist spraying
      Production processes:
      1. One intermediate coat, guiding the layer of paint
      2. Plate polishing
      3. Scrape atomic dust, repair defects, and polish
      4. Intermediate coating for secondary defect repair, guiding the coating
      5. Flat polishing
      6. Minor defect repair, scraping atomic ash, red ash, polishing
      7. Repair the intermediate coat and apply the entire vehicle's guiding layer of paint
      8. After the flat plate is cleaned and polished, the guiding layer of paint is applied
  • IK metallic paint 1K solid paint
    • 2-layer 20-25 microns
      Spray method: Two layers of single layer or one layer plus one layer, with a 5-minute interval between each layer.
  • 2K solid paint
    • 2-layer 40-60 microns
      Spray method: One layer of mist spray, followed by two layers of wet spray, with an interval of 10-15 minutes between each layer
  • Topcoat varnish
    • 2-layer 40-60 microns
      Spray method: One layer of mist spray, followed by two layers of wet spray, with each layer spaced 10-15 minutes apart
  • Polishing and waxing
    • 1. First, use P1200 or P1500 sandpaper for water grinding to smooth out the dust particles on the surface of the paint layer.
      2. Polish with coarse wax and remove the sandpaper grain to achieve a glossy and smooth paint surface.
      3. Using polishing wax water for surface polishing and protection can maintain long-lasting luster.
  • Subscribe to Our Newsletter​​​​​​​
  • get ready for the future
    sign up for our newsletter to get updates straight to your inbox
    Submit
Copyright ©️  2023 Guangde Dulux Paint Industry Co., Ltd. All rights reserved｜ Sitemap｜ Privacy Policy | Supported by leadong.com